Be careful, however this may make the paper clips you’ve inserted pop out and go flying. It may take a bit of force, but the shell should separate without too much of a fight. Separate the two halves of the cartridge by pulling them apart gently, starting from the filament spout. Repeat until all required tabs are unlocked. Make sure they’re stable in place you don’t want to lose progress. This will help separate the two halves to the cartridge and prevent any re-locking. Use the small screwdriver to push in each of the tabs that are found along the seam, inserting a paperclip (or alternative shim) as you go. Guide it along the edges and be careful! While the cartridge may not be made of glass, you don’t want to carelessly damage it and render it permanently useless.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |